Once you are in the Options Screen,Select the correct port for your PC’s USB Port (USB) or Serial Port (typically COM1 or COM2) and click the button. If the Interface Status is “Not Found!”,check the connections at the car and PC.Make sure both are plugged in securely.Serial Interfaces get their power from the vehicle so they will not be recognized at all if not plugged into a car.Īdapter Type should always be “RossTech” followed by the name of the Interface such as “HEX-USB+CAN”. Version indicates the firmware version of your Interface. It may be updated by new versions of VCDS, if so follow the prompts on the screen. Once you have tested successfully, click then click to apply this configuration,you will be returned to the Main Screen. Select one of your car’s Control Modules such as Engine.Ĭlick on to view the Select Control Module Screen. Note: Your car will not have all the Control Modules listed in VCDS, only the functional ones that were installed in your vehicle.Īfter VCDS has connected, click on to check for Fault Codes (DTCs).Repeat the process for each of your car’s Control Modules.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |